Electric Clock - Mechanical Substitutes

Electric Clock - Mechanical Substitutes

All of the antique clock movements that are electric and have a wood clock case are obsolete. They are no longer available and not worth repairing. Parts are not available, the movement is useless and the clock looks like its heading for the dump. Such as shame when the clock is part of the family history.

There is something that can be done in this situation. Putting a quality mechanical unit as a substitute in the clock case could save the clock and have it running again. It would be a wind up mechanical unit and it will run 8 days every time its fully wound up. The clock will be functioning again and with a high quality movement.

Nice substitutes for the electric clock

The 8 day wind up Hermle 130-678 or 130-627 can be easily mounted in most tambour style clock cases. These are good substitutes to replace an obsolete electric motor clock movement.

Having a back wind mechanical unit such as one of these, there are no concerns with drilling holes in the clock dial to wind it up. Now lets look at some mechanical substitutes for the obsolete electric clock movements.

The Hermle 130-678 clock movement

The 130-678 unit is a bell strike unit that comes with the bells on it. 130-678 is the easiest unit to adapt to a clock case that contained an obsolete electric clock movement. This unit mounts to the wooden clock case with some wood screws only. Needs with it >new hands</a for the new movement. Any of the German mechanical clock hands seen at the top of [this link](/clock-hands/clock-hands.html)

The winders are on the back, no dial holes to drill out
No chimeblock to mount because the movement comes with bells on it
Compact movement fits into the tightest of places

The Hermle 130-627 clock movement

The 130-627 unit is a bottom 3 hammer strike, so if the current electric movement has three rods below, this will work with it. If anything other than this as far as the strike goes, it would need to also get the chime block with the movement.

This unit will take chime block style A with 3 rods and most likely 7 inch length. The length of the rods does not matter so much, just the longer the rod the deeper the tone.
This also needs new hands for the new movement. any of the German mechanical clock hands will fit.

130-678

Balance Escapement
2 Bells back
8 Day Wind Up
Back Wind

Front
Side
Side
Back
View Product

130-627

Balance Escapement
3 Hammer Below
Bim Bam Strike
Back Wind

Front
Side
Back
View Product

[post-content id=100711 shortcodes="true"]

Updated on: 20/12/2024