How do I mount a QU40 Clock Movement?
Put the black rubber washer over the fat threaded post that takes the hex nut.
Mount the movement from the back of the dial to the front and install the brass washer, then the hex nut to secure the movement to the back of the dial.
Install the hour hand by friction fit only, twist and push on at once.
Install the minute hand next with its nut to hold it on. If using a second hand, use the nut with the hole in it. If no second hand the cap nut can be used instead of the nut with the hole in the center.
If using a second hand, push it into the center of the hand shaft hole, this is also only a friction fit.
Mount the movement from the back of the dial to the front and install the brass washer, then the hex nut to secure the movement to the back of the dial.
Install the hour hand by friction fit only, twist and push on at once.
Install the minute hand next with its nut to hold it on. If using a second hand, use the nut with the hole in it. If no second hand the cap nut can be used instead of the nut with the hole in the center.
If using a second hand, push it into the center of the hand shaft hole, this is also only a friction fit.
Updated on: 05/08/2022
Thank you!